How to Format USB Drive for use with Mazak and Floppy Emulator Connect

How to Format USB Drive for use with Mazak and Floppy Emulator Connect

Overview

Mazaks require a special formatting on floppy disks to function so the same will hold true when using our Floppy Emulator Connect. 

Formatting the USB Drive

  1. Plug in USB drive into the Floppy Emulator Connect
  2. Red light on Floppy Emulator Connect begins to flash 
  3. Press RESET button on Floppy Emulator Connect
  4. Red light will stop flashing 
  5. On the Mazak, Press DATA IN/OUT
  6. Press FLOPPY softkey
  7. Press FD FORMAT softkey
  8. Enter "-9999" then press INPUT
  9. Press START softkey 
  10. USB drive will now be formatted 

    • Related Articles

    • Floppy Connect 2.0 Installation and Operation Guide for Mazak 640

      Overview The Floppy Connect 2.0 emulator replaces your existing floppy drive & acts as if it were never removed. This article is for Mazak Mazatrol 640M & 640T machines only. USB Flash Drive Requirements USB flash drive that is 32GB or less; SFA ...

    • Floppy Connect Emulator Installation Guide for Universal Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...

    • Floppy Connect Emulator Installation Guide for Haas Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. This article is for the Haas model only. USB Flash Drive Requirements We recommend using the included SFA USB flash drive. USB drive must be ...

    • Floppy Connect Emulator Installation Guide for IBM Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...

    • How to Format a USB Flash Drive to FAT

      Overview Floppy Connect requires a USB flash drive to be formatted as FAT or FAT16. In addition, the Floppy Connect requires a drive to be 2GB or smaller. This knowledge base is written for Windows 10 or newer, however, steps for older operating ...