How to Change Mori-Server Permissions

How to Change Mori-Server Permissions

Overview

DMG Mori (Mori Seiki) machines with networking capabilities support sending and receiving program directly to and from the CNC memory via the Predator DNC DMG Mori MAPPS Terminator. In most cases, the only requirement is the MAPPS control is connected to the network, but sometimes additional settings need to be configured on the MAPPS control. 

Change Mori-Server Permissions

  1. Press SYSTEM button
  2. Press I/O softkey
  3. Press far-left (<) softkey
  4. Press COMM. SETNG softkey
  5. Press 4 to select "Network I/O Setting"
  6. Press SERVER DETAIL softkey
  7. Change to PERMIT for "NC PROGRAM INPUT/OUTPUT", "FOREGROUND PROGRAM", "BG EDIT PROGRAM", and "NC PROGRAM"
  8. Restart the CNC control when complete

    • Related Articles

    • How to change DMG Mori Seiki MAPPS DNC mode from RS-232 to Internal Card

      Overview Mori Seiki controls can come with "Internal Card" which is similar to a Fanuc Data Server, and may even be found on the same machine as a Data Server, but is a separate memory space from the rest of the machine, including Data Server or Main ...

    • DMG Mori and Mori Seiki MAPPS Parameters

      Controls MAPPS MAPPS II MAPPS III MAPPS IV Notate or take a picture of any parameters before you change them Change DMG Mori Parameters Put control in MDI mode Press SETTING button Press I/O PARAM. Set Baud Rate to "9600" Set OUTPUT NULL to "0" Set ...

    • How to Change Fanuc IO Channel

      Overview How to change the I/O channel on a modern Fanuc control. I/O Channels Channel Description 0, 1 RS-232C Serial Port 1 2 RS-232C Serial Port 2 4 Memory Card Interface (PCMCIA) 5 Data Server Interface 9 Embedded Ethernet Interface (FTP) 17 USB ...

    • How to Toggle Fanuc Data Server Modes

      Overview Fanuc Data Servers allow you to change how they handle file transfers; these are called DS Modes. Change Data Server Mode Press SYSTEM button Press far-right softkey (+) until you see ETHER NET, press it Press far-right softkey (+) until you ...

    • How to Change Fanuc FTP Host

      Overview When using FTP with a Fanuc, you can have up to three hosts configured. This article includes steps to toggle between the different hosts. Requirements Fanuc control with configured FTP Host (How to Configure Fanuc FTP Settings) Changing FTP ...