How to Configure DMG Mori CELOS Network Settings

How to Configure DMG Mori CELOS Network Settings

Overview

This article includes steps to configure network settings on a DMG Mori CELOS control. 

Controls

  1. MAPPS V

Requirements

  1. Static IP Address, Subnet Mask, & Gateway
  2. Network Drop

Configure Network Settings

Warning
Notate or take a picture of any settings before making changes
  1. Press Emergency Stop on control
  2. Press Edit on the upper-right portion of the screen
  3. From the right-side menu, go to Maintenance > Setting > Communication Setting
  4. Select Communication Setting and drag it over to the main window; the main window will light up green as you drag the Communication Setting window over to it
  5. Enter IP address, subnet mask, default gateway
  6. Press the save icon (floppy disk) toward the bottom to save your settings

Finalize Configuration

  1. Turn the CNC Control off then back on to apply changes




    • Related Articles

    • How to Configure DMG Mori MAPPS Network Settings

      Overview This article includes steps to configure network settings on a DMG Mori MAPPS control. Controls MAPPS III & IV Requirements Static IP Address, Subnet Mask, & Gateway Network Drop Preparation Plug into only one of the following network ports ...

    • How to Configure Fanuc Network and FOCAS Settings

      Overview This article includes steps to configure network and FOCAS settings. Requirements Static IP Address, Subnet Mask, & Gateway Network Drop Controls Fanuc 16i-MB, 16i-TB, 160i-MB, 160i-TB, 160is-MB, 160is-TB Fanuc 18i-MB, 18i-TB, 180i-MB, ...

    • How to change DMG Mori Seiki MAPPS DNC mode from RS-232 to Internal Card

      Overview Mori Seiki controls can come with "Internal Card" which is similar to a Fanuc Data Server, and may even be found on the same machine as a Data Server, but is a separate memory space from the rest of the machine, including Data Server or Main ...

    • How to Set Citizen Cincom Network Settings

      Controls Known to work on modern Citizen CINCOM controls Requirements Static IP address, subnet mask, and gateway Notate or take a picture of any parameters before you change them Enable Parameter Write Press MAINT. button Press I/F Diag softkey Type ...

    • How to Configure Haas NGC Network Settings

      Overview This will go over how to configure the wired Ethernet settings and Net Share on a Haas Next Generation Control. Configure Wired Connection settings Press SETTING button Go to Network tab Go to Wired Connection tab To set the following ...