How to Configure DMG Mori MAPPS Network Settings
Overview
This article includes steps to configure network settings on a DMG Mori MAPPS control.
Controls
- MAPPS III & IV
Requirements
- Static IP Address, Subnet Mask, & Gateway
- Network Drop
Preparation
- Plug into only one of the following network ports
- Electrical cabinet (i.e. rear cabinet); port is commonly labeled CN6 and/or NET
- Behind the LCD (i.e. pendant), port is commonly labeled CN6
Depending on the NC system backend, there may be more than one network port
Notate or take a picture of any settings before making changes
- Press SYSTEM button
- Press < softkey
- Press COMM. SETNG (F5)
- Type 1 for "NETWORK BASIC SETTING"
- Press INPUT button
- Set DHCP Function to "INVALID" (blue indicates selected; this is default)
- To set the following settings, select the field, type the value, then press INPUT button
- Set IP Address with your static IP address
- Set SUBNET MASK with your subnet mask
- Set Default Gateway with your gateway
- Press SET (F9)
- Press RETURN (F10)
Finalize Configuration
- Turn the CNC Control off then back on to apply changes
Related Articles
How to Configure Fanuc Network and FOCAS Settings
Overview This article includes steps to configure network and FOCAS settings. Requirements Static IP Address, Subnet Mask, & Gateway Network Drop Preparation Plug network cable into CD38A port, this is typically located in the main electrical cabinet ...
How to Configure Fanuc FTP Settings
Overview This article includes steps to configure FTP and set the appropriate I/O channel to send to and from a FTP server. In this case, the CNC machine acts as the FTP client. Requirements CNC Connected to Network FTP Server IP Address FTP Server ...
How to Configure Haas NGC Network Settings
Overview This will go over how to configure the wired Ethernet settings and Net Share on a Haas Next Generation Control. Configure Wired Connection settings Press SETTING button Go to Network tab Go to Wired Connection tab To set the following ...
How to Set Citizen Cincom Network Settings
Controls Known to work on modern Citizen CINCOM controls Requirements Static IP address, subnet mask, and gateway Notate or take a picture of any parameters before you change them Enable Parameter Write Press MAINT. button Press I/F Diag softkey Type ...
How to Configure Siemens 840D sl Network Settings
Overview This article will review how to configure the Siemens 840D sl (Solution Line) network settings. This is also referred to as the Siemens 840D with Operate. Requirements Network Drop Manufacturer Password SFA Technical Support can provide this ...