Overview

Obtain HMI Version

Recommend taking pictures of requested screens to avoid any typos. 

1. Press Menu Select
   
2. Press Diagnosis
   
3. Press Service Displays
   
4. Press Version
   
1. On "NCU Version" page, notate the numbers under "Version Data NCU" (e.g. 06.05.39)
   
2. On "HMI Version" page, notate the HMI System Software (record the entire HMI Version number)
   

Obtain MAC Address

Enter Password

This step is only needed if control is not in manufacture mode; if in doubt, proceed to set the password

1. Press Menu Select
   
2. Press Start-up
   
3. Press Password...
   
4. Press Set password
   
5. Enter "SUNRISE" as the password
   

Open DOS Shell (Command Prompt) and Find MAC Address

1. Press Menu Select
   
2. Press MMC or HMI, whichever appears
   
3. Press DOS Shell
   
4. In the DOS shell window, type "ipconfig /all"
   
5. Notate the "IP Address" and "Physical Address" (i.e. MAC address)
   

Clear Password

This step is only needed if control was not in manufacture mode; if in doubt, proceed to clear password

Clearing password does not "delete" it contrary to Siemens terminology, it only put the control back into operator mode

Provide Information to SFA

1. Send requested information to your Account Executive or to support@shopfloorautomations.com