How to Set Citizen Cincom Network Settings

How to Set Citizen Cincom Network Settings

Controls

  1. Known to work on modern Citizen CINCOM controls

Requirements

  1. Static IP address, subnet mask, and gateway
Notate or take a picture of any parameters before you change them

Enable Parameter Write

  1. Press MAINT. button
  2. Press I/F Diag softkey
  3. Type "1001//M"
  4. Press INPUT button

Set Network Settings

  1. Press PRM. button
  2. Press Menu SEL softkey until you see "BAS COM."
  3. Press BAS COM. softkey
  4. Change the following parameters
    1. No. 1925 Ethernet to "1"
    2. No. 1926 Global IP address to your static IP address
    3. No. 1927 Global Subnet mask to your subnet mask
    4. No. 1928 Global Gateway to your gateway
  5. Reboot the control

    • Related Articles

    • Citizen Cincom RS-232 Parameters

      Controls Known to work on modern Citizen CINCOM controls Notate or take a picture of any parameters before you change them Change Citizen Parameters Put control in EDIT mode Press LIST softkey Press I/O softkey Press 232C Set softkey Input/Output ...
    • How to Configure Fanuc Network and FOCAS Settings

      Overview This article includes steps to configure network and FOCAS settings. Requirements Static IP Address, Subnet Mask, & Gateway Network Drop Preparation Plug network cable into CD38A port, this is typically located in the main electrical cabinet ...
    • How to Configure Haas NGC Network Settings

      Overview This will go over how to configure the wired Ethernet settings and Net Share on a Haas Next Generation Control. Configure Wired Connection settings Press SETTING button Go to Network tab Go to Wired Connection tab To set the following ...
    • How to Configure Siemens 840D sl Network Settings

      Overview This article will review how to configure the Siemens 840D sl (Solution Line) network settings. This is also referred to as the Siemens 840D with Operate. Requirements Network Drop Manufacturer Password SFA Technical Support can provide this ...
    • How to Configure DMG Mori MAPPS Network Settings

      Overview This article includes steps to configure network settings on a DMG Mori MAPPS control. Controls MAPPS III & IV Requirements Static IP Address, Subnet Mask, & Gateway Network Drop Preparation Plug into only one of the following network ports ...