Operator Guide - Fanuc 0

Operator Guide - Fanuc 0

Overview

This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control.

Controls Supported

  1. Fanuc 0-M
  2. Fanuc 0-T

How to Punch

  1. Put control in EDIT mode
  2. Press PROG button
  3. Type in program number, e.g. "O1234"
  4. Press down cursor 
  5. Press (OPRT) softkey
  6. Press PUNCH softkey
  7. Press EXEC softkey

How to Read

  1. Put control in EDIT mode
  2. Press PROG button
  3. Press (OPRT) softkey
  4. Press READ softkey
  5. Press EXEC softkey


    • Related Articles

    • Operator Guide - Fanuc 16i, 18i, & 21i

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Fanuc 16i Fanuc 18i Fanuc 21i How to Punch Put control in EDIT mode Press PROG button Press DIR ...

    • Operator Guide - Fanuc 0i Model F

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Fanuc 0i-MF Fanuc 0i-TF How to Punch Put control in EDIT mode Press PROG button Press FOLDER softkey ...

    • Operator Guide - Fanuc 0i Model D

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Fanuc 0i-MD Fanuc 0i-TD How to Punch Put control in EDIT mode Press PROG button Press DIR softkey ...

    • Operator Guide - Mori Seiki MSC-500s

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported MSC-500 (Fanuc 21i) MSC-501 (Fanuc 18i) MSC-502 (Fanuc 16i) MSC-521 (Fanuc 21i) MSC-518 (Fanuc 18i) ...

    • How to Switch Between Doosan EZ Guide and Fanuc NC

      Overview Doosan machines have EZ Guide. Unfortunately, EZ Guide does not allow for serial RS232 program transfers. Luckily, it is easy to switch back and forth. Switch to NC (Classic Fanuc Interface) Press CUSTOM1 button Press NC-P Press PROG button ...