Operator Guide - Haas Classic Control

Operator Guide - Haas Classic Control

Overview

This will explain how to output a program (send) from the CNC control and input a program (read) into the CNC control. 

Controls Supported

  1. Haas Classic Control (CHC) - 2016 or older

How to Send

  1. Press LIST PROGRAM button
  2. Using the cursor, select the program you with to send
  3. Press SEND or SEND RS-232 button

How to Read

  1. Press LIST PROGRAM button
  2. Press END to highlight "ALL"
  3. Press RECV or RECV RS-232 button

How to Drip Feed (DNC)

  1. Press MDI DNC button (first press puts it in MDI mode)
  2. Press MDI DNC button (second press puts it in DNC mode)
  3. Press CYCLE START button

    • Related Articles

    • Parameters - Haas Classic Control

      Controls Any Haas with a RS-232 Port (usually 2016 or older, formally called Classic Haas Control or CHC) Notate or take a picture of any parameters before you change them Set Parameters Standard Transfers (Default) Press SETNG GRAPH button Press ...

    • Operator Guide - Fanuc 0

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Fanuc 0-M Fanuc 0-T How to Punch Put control in EDIT mode Press PROG button Type in program number, ...

    • Operator Guide - Mazak Fusion 640

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Mazatrol Fusion 640M, 640M, 640M 5X, 640M Nexus, 640M Pro Mazatrol Fusion 640T, 640TE, 640TN, 640T ...

    • Operator Guide - Fanuc 0i Model F

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Fanuc 0i-MF Fanuc 0i-TF How to Punch Put control in EDIT mode Press PROG button Press FOLDER softkey ...

    • Operator Guide - Fanuc 0i Model D

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Fanuc 0i-MD Fanuc 0i-TD How to Punch Put control in EDIT mode Press PROG button Press DIR softkey ...