Unable to receive G Code on the USB Connect Mazak?

Unable to receive G Code on the USB Connect Mazak?

Problem

I am unable to send/receive G code using my USB Connect Mazak, but I can send/receive Mazatrol with no issues. 

Reason

Sending/receiving Mazatrol programs requires the Flow Control be set to CMT Ver. 1 or CMT Ver. 2.

Solution

Change Flow Control to SW Xon/Xoff

    • Related Articles

    • USB Connect Operation Guide

      Overview This KB is intended as an operation manual for the USB Connect devices. This will apply to both the pendant mount and portable model. Requirements The USB Connect device will work with a CNC control with a standard DB25 RS-232 serial ...

    • USB LAN Connect - Mazak Settings

      Overview The USB LAN Connect - Mazak allows transferring Mazatrol programs in and out of the Mazak control. The following KB will review the unique parameters to be used on the device to communicate via the CMT protocol. Requirements USB LAN Connect ...

    • USB LAN Connect Operation Guide

      Overview This KB is intended to provide a description of the USB LAN Connect network FTP data server. The USB LAN Connect is an FTP server with at least 2 GB of local memory stored on a removable SD card. Data can be accessed over a LAN network as ...

    • Floppy Connect Emulator Installation Guide for Haas Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. This article is for the Haas model only. USB Flash Drive Requirements We recommend using the included SFA USB flash drive. USB drive must be ...

    • USB LAN Connect Display not Working

      Overview If the USB, USB LAN, and LAN Connect screen display is not working, try the following solutions. If all fail, contact Shop Floor Automations. Check the Display Cable The gray display cable could be pinched, make sure it is not stuck between ...