What causes a Mazak parity error?

What causes a Mazak parity error?

Problem

When parameters match on the Mazak and PC/USB, the machine is getting a parity H or set new paper tape error. 

Reason

When transferring EIA (i.e. Tape, G-Code) programs in and out of a Mazak, the data, parity, and stop bit should mismatch. 

Solution

Machine should be 8 None 1 or sometimes 8 None 2 while the computer should be 7 Even 2. 

    • Related Articles

    • Mazak Mazatrol 640 RS-232 Parameters

      Controls Mazatrol 640T, 640M Mazatrol 640T, 640M Nexus PC-Fusion-CNC Notate or take a picture of any parameters before you change them Set TAPE (EIA) Parameters Press far-left softkey Press DATA I/O Press TAPE Press PARAM. Set BAUDRATE to "19200" ...

    • Operator Guide - Mazak Fusion 640

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Mazatrol Fusion 640M, 640M, 640M 5X, 640M Nexus, 640M Pro Mazatrol Fusion 640T, 640TE, 640TN, 640T ...

    • How to Configure HD I/O Folder on Mazak Mazatrol SmoothG, SmoothX, and SmoothAi Controls

      Overview The HD I/O Folder is used to transfer programs between the hard drive and the NC. This article explains how to set this folder. Requirements Path of desired folder on machine control, e.g. "C:\ymw\M8Y\data\MC_Backup\Predator” The folder ...

    • How to Access Windows on Mazak Smooth

      Overview Accessing Windows on a Mazak Smooth control (windows-based) is necessary to set network settings, configure MTConnect, and setting up shares. Requirements Windows-based Smooth Control Accessing Windows Press the far-left softkey to reveal ...

    • Why is my Fanuc getting an Abnormal End error?

      Problem When trying to send a program from a Fanuc using FTP, an error pops up saying "Abnormal End". Solutions Change the main program (active program) to something else. Then try again. Confirm the machine is connected to the network by attempting ...