Why can I send programs and read/write from the Haas Floppy Emulator, but I can't save programs back to it?

Why can I send programs and read/write from the Haas Floppy Emulator, but I can't save programs back to it?

Here are some steps to look into taking for this issue.

  • Does the Haas say FLOPPY DONE when you attempted to save a file to the Floppy Connect?
  • If YES, then do an F4 command on the Haas and select EDIT to view the DIR (Directory) of the floppy emulator.
  • Is the program that you were trying to save shown in the DIR?
  • If YES, then before you remove the USB flash drive from the emulator, push the round RES button on the front of the emulator
  • Wait for a moment until all the LEDs stop flashing
  • After the flashing LEDs stop, then remove the USB flash drive
  • Take the USB stick to your PC to confirm the files have saved on the drive

    • Related Articles

    • Unable to Save Programs to Floppy Connect on a Haas

      Problem I am unable to save programs back to the Floppy Connect (emulator) on a Haas, but I can load programs from it. Solutions Does the Haas say "FLOPPY DONE" when you attempted to save a file to the Floppy Connect? If yes, then press F4 on the ...

    • Floppy Connect Emulator Installation Guide for Haas Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. This article is for the Haas model only. USB Flash Drive Requirements We recommend using the included SFA USB flash drive. USB drive must be ...

    • LED Status Lights on the Floppy Connect Emulator

      Green LED Status Light The green light indicates a floppy read or write operation has been done. No green light at all, or solid green light, indicates a problem. Red LED Status Light The red light indicates that the USB drive is inserted. The red ...

    • Floppy Connect Emulator Installation Guide for Universal Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...

    • Floppy Connect Emulator Installation Guide for IBM Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...