Notate or take a picture of any parameters before you change them

Change Yasnac Parameters

1. Press PROG key
   
2. Press far right UP/DOWN softkey to select top row of softkeys (indicated by outlines)
   
3. Press IN/OUT softkey
   
4. Press RS232C softkey
   
5. Change the following parameters in both IN and OUT columns
   
Changes are done by selecting the parameter and choosing the appropriate softkey
1. PORT to "NO. 2"
   
2. UNIT to "RS232C"
   
3. BPS to "9600"
   
4. STOP BIT to "2BITS"
   
5. PARITY to "EVEN"
   
6. XON/XOFF to "ON"
   
7. RTS CNTRL to "OFF"
   
8. PARITY ISO to "OFF"