How to Program Moxa NPort 5110

How to Program Moxa NPort 5110

Overview

This article will go over the steps to program a Moxa NPort 5110 unit. 

Requirements

  1. PC with available Ethernet port
  2. Ethernet Cable
  3. 12-48vdc Power Supply (12vdc included)
  4. Device Search Utility (DSU)
  5. Static IP Address, Subnet Mask (Netmask), & Gateway

Preparation

  1. Download and install DSU (link)

Configure Network Settings

  1. Plug in Ethernet cable between Ethernet port located on the top of the unit and your PC Ethernet port
  2. Plug power supply into Moxa
  3. Launch DSU
  4. Click Search and wait for it to complete
  5. Verify the MAC address matches the white label on the back of the unit
  6. Click the device in DSU to highlight
  7. Click Un-Lock (If this is grayed out, skip to step 9)
    1. Username: "admin"; password: "moxa"
    2. Click the device in DSU to highlight
    3. Click Assign IP
    4. Enter IP Address, Netmask, and Gateway
    5. Press OK then wait for it to complete

    6. If successful, Press OK
    7. A new search will automatically start, confirm the same Moxa appears with the correct IP address
    8. Unplug Ethernet cable and plug Moxa NPort 5110 into your network

    Troubleshooting

    1. Confirm you are plugged directly into Moxa Ethernet port from your computer. Plugging the Moxa to the general network in its default state will not let you properly set an IP address.
    2. Confirm you are using default IP (DHCP option) for your computers network card. This means you are not using a static IP address on your computer.
    3. Change your computers network card IP to 192.168.127.100; Subnet Mask is 255.255.255.0; Gateway is blank
    4. Try to access the web console (http://192.168.127.254) and program it from there. The username and password from above still apply. 
      1. Go to Network Settings and enter the static IP address, Subnet Mask, and Gateway; click Submit when done. 

    Drivers

    1. To install drivers, review How to Install Moxa NPort Drivers


      • Related Articles

      • How to Back Up and Restore Moxa NPort Drivers

        Overview When moving your software to a new PC/Server, you must migrate the device drivers as well. This guide will assist with backing up and restoring Moxa NPort drivers. Requirements Local Administrator Rights Access to both old and new computers ...

      • How to Program Moxa NPort P5150A

        Overview This article will go through the steps to program a Moxa NPort P5150A unit. Requirements PC with available Ethernet port Ethernet Cable 12-48vdc Power Supply (12vdc included) Device Search Utility (DSU) Static IP Address, Subnet Mask ...

      • How to Program Moxa NPort 5210A

        Overview This article will go through the steps to program a Moxa NPort 5210A unit. Requirements PC with available Ethernet port Ethernet Cable 12-48vdc Power Supply (12vdc included) Device Search Utility (DSU) Static IP Address, Subnet Mask ...

      • How to Program Moxa NPort W2150A & W2250A

        Overview This article will go through the steps to program a Moxa NPort W2150A & W2250A unit. Requirements PC with available Ethernet port Ethernet Cable 12-48vdc Power Supply (12vdc included) Device Search Utility (DSU) Static IP Address, Subnet ...

      • How to Program Moxa AWK-1137C

        Overview This article will go through the steps to program a Moxa AWK-1137C unit. Requirements PC with available Ethernet port Ethernet Cable 12-48vdc Power Supply (12vdc included) Static IP Address, Subnet Mask (Netmask), & Gateway SSID Wi-Fi ...