USB LAN Connect - Mazak Settings

USB LAN Connect - Mazak Settings

Overview

The USB LAN Connect - Mazak allows transferring Mazatrol programs in and out of the Mazak control. The following KB will review the unique parameters to be used on the device to communicate via the CMT protocol.

Requirements

  1. USB LAN Connect - Mazak

Connect Device Parameters for the CMT Protocol

  1. Baud Rate
    1. Set to 4800
  2. Data/Parity/Stop
    1. Set to 8 data, no parity, 2 stop bit
  3. Flow Control
    1. Set to CMT Ver 1 for the older controls
    2. Set to CMT Ver 2 for the newer controls
    If CMT Ver 1 doesn't work, try CMT Ver 2, and vice versa.
  4. End of Block Char
    1. Set to None/binary
  5. End of Block Delay
    1. Set to No delay
  6. Start of Tx
    1. Set to none
  7. End of Tx
    1. Set to none
  8. Start Rx
    1. Set to Automatic

    • Related Articles

    • LAN-USB Connect Operation Guide

      Overview This KB is intended to provide a description of the LAN-USB Connect network FTP data server. The LAN-USB Connect is an FTP server with at least 2 GB of local memory stored on a removable SD card. Data can be accessed over a LAN network as ...

    • USB/LAN Connect Display not Working

      Overview If the USB/LAN Connect screen display is not working, try the following solutions. If all fail, contact Shop Floor Automations. Check the Display Cable The gray display cable could be pinched, make sure it is not stuck between anything You ...

    • LAN Connect Operation Guide

      Overview This KB is intended to provide a description of the LAN Connect network FTP data server. The LAN Connect is an FTP server with at least 2 GB of local memory stored on a removable SD card. Data can be accessed over a LAN network as well as ...

    • USB Connect Operation Guide

      Overview This KB is intended as an operation manual for the USB Connect devices. This will apply to both the pendant mount and portable model. Requirements The USB Connect device will work with a CNC control with a standard DB25 RS-232 serial ...

    • Floppy Connect Emulator Installation Guide for Universal Model

      Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...