What kind of USB flash drives can be used with a floppy drive emulator on my CNC?
You must use a USB flash drive that is 2GB or smaller. The flash drives must be formatted as “FAT” or “FAT-16.” 32-bit FAT (“FAT-32”) will NOT work with the floppy emulator. Review
How to Format a USB Flash Drive to FAT to convert any compatible USB flash drive.
Related Articles
Floppy Connect Emulator Installation Guide for IBM Model
Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...
How to Format a USB Flash Drive to FAT
Overview Floppy Connect requires a USB flash drive to be formatted as FAT or FAT16. In addition, the Floppy Connect requires a drive to be 2GB or smaller. This knowledge base is written for Windows 10 or newer, however, steps for older operating ...
Floppy Connect Emulator Installation Guide for Haas Model
Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. This article is for the Haas model only. USB Flash Drive Requirements We recommend using the included SFA USB flash drive. USB drive must be ...
Floppy Connect USB Flash Drive Compatibility
The Floppy Connect must use a USB flash drive of 2 GB or smaller. The USB flash drives must be formatted as FAT or FAT-16. FAT-32 or exFAT will not work with the Floppy Connect. Reach out to your Shop Floor Automations Account Executive to purchase a ...
Floppy Connect Emulator Installation Guide for Universal Model
Overview The Floppy Connect Emulator emulates your existing floppy drive & acts as if it were never removed. Works with almost any existing 720KB/1.44MB capacity DOS format floppy drive. 28 or 32 pin ribbon cables systems are supported & will connect ...