Why is my Fanuc getting an Abnormal End error?

Why is my Fanuc getting an Abnormal End error?

Problem

When trying to send a program from a Fanuc using FTP, an error pops up saying "Abnormal End".

Solutions

  1. Change the main program (active program) to something else. Then try again. 
  2. Confirm the machine is connected to the network by attempting to ping it from the Predator DNC PC

    • Related Articles

    • NC Program Format - Fanuc

      Overview The following is how a Fanuc program is formatted. This provides no guidance on G and M code, only format. Program Naming O number, e.g. O1234 This is the most common Numeric only Can be called by M98 Leading zeros are not necessary, e.g. ...

    • Why does my Fanuc give "The Wrong Data is Used" error message?

      Problem When trying to send, punch, or output a program, the Fanuc give an error "The Wrong Data is Used". Reason This is a syntax error and most likely due to how the program name or number is being typed. In some cases, this is also due to the ...

    • What are the Fanuc Alarms?

      Overview This is a list of common Fanuc alarms and some solutions. Alarms 070 - No Program space in memory - The memory area is insufficient Delete any unnecessary programs and try again 071 - Edit Lock Key Turn off program protect and try again 072 ...

    • How to Ping from a Fanuc Control

      Overview Pinging from the Fanuc control is an important troubleshooting step to determine of the CNC machine can talk to the network and/or a computer. Controls Fanuc 0i-MD, 0i-TD, 0i-MF, 0i-TF Fanuc 30i Model A, Model A5, Model B, Model B5 Fanuc 31i ...

    • What causes a Mazak parity error?

      Problem When parameters match on the Mazak and PC/USB, the machine is getting a parity H or set new paper tape error. Reason When transferring EIA (i.e. Tape, G-Code) programs in and out of a Mazak, the data, parity, and stop bit should mismatch. ...