Recent Articles
How to Set Fanuc 10, 11, 12, & 15 RS-232 Parameters
Controls Fanuc 10M, 10T, 11M, 11T, 12M, 12T, 15M, 15T Notate or take a picture of any parameters before you change them Change Fanuc Parameters Set write key to enable Put control in MDI mode Press far left softkey until you see SETTING softkey Press ...
How to Turn On/Off Offline Reporting for Moxa NPort Devices
Overview Moxa NPort drivers will report to Predator DNC when they are offline. This is configured by default by SFA. If your network is prone to connectivity issues, it might be wise to turn off this reporting until you can resolve the network ...
How to Configure Haas NGC DPRNT
Overview Haas with Next Generation Control (NGC) allows DRPNT, but not using the traditional RS232 port. You can export DPRNT statements using a TCP port or save it to a file. This is a common practice to collect probe data from the control. Set ...
What is Predator MDC Run-time error '372'?
Problem When trying to run a report in Predator MDC , "Run-time error '372': Failed to load control 'CRViewer' from crviewer.dll. Your version of crviewer.dll may be outdated. Make sure you are using the version of the control that was provided with ...
Predator CNC Editor unable to send a program to a Fanuc 0M
Problem Able to receive on the PC from the Fanuc 0M, but cannot load a file into the Fanuc; no errors and no LSK flashing. This while using Predator CNC Editor and a USB to Serial device. Solution RTS and DTR must not me checked in Predator CNC ...