How to Configure HD I/O Folder on Mazak Mazatrol SmoothG, SmoothX, and SmoothAi Controls

How to Configure HD I/O Folder on Mazak Mazatrol SmoothG, SmoothX, and SmoothAi Controls

Overview

The HD I/O Folder is used to transfer programs between the hard drive and the NC. This article explains how to set this folder. 

Requirements

  1. Path of desired folder on machine control, e.g. "C:\ymw\M8Y\data\MC_Backup\Predator”
Info
The folder selected cannot be the final destination and must have at least one subfolder.
Info
The subfolders cannot contain spaces.

Configure HD I/O Folder

  1. Press DATA I/O
  2. Press HARD DISK
  3. In the upper right corner, press the gear icon
  4. Go to Setup > HD I/O Folder
  5. Press BROWSE
  6. Navigate to the desired folder
  7. Press OK

    • Related Articles

    • Mazak Mazatrol 640 RS-232 Parameters

      Controls Mazatrol 640T, 640M Mazatrol 640T, 640M Nexus PC-Fusion-CNC Notate or take a picture of any parameters before you change them Set TAPE (EIA) Parameters Press far-left softkey Press DATA I/O Press TAPE Press PARAM. Set BAUDRATE to "19200" ...

    • Operator Guide - Mazak Fusion 640

      Overview This will explain how to output a program (punch) from the CNC control and input a program (read) into the CNC control. Controls Supported Mazatrol Fusion 640M, 640M, 640M 5X, 640M Nexus, 640M Pro Mazatrol Fusion 640T, 640TE, 640TN, 640T ...

    • What causes a Mazak parity error?

      Problem When parameters match on the Mazak and PC/USB, the machine is getting a parity H or set new paper tape error. Reason When transferring EIA (i.e. Tape, G-Code) programs in and out of a Mazak, the data, parity, and stop bit should mismatch. ...

    • How to Configure Fanuc FTP Settings

      Overview The article provides instructions on configuring FTP and establishing the correct I/O channel for transferring data to and from an FTP server. Here, the CNC machine functions as the FTP client. Requirements CNC Connected to Network (How to ...

    • How to Access Windows on Mazak Smooth

      Overview Accessing Windows on a Mazak Smooth control (windows-based) is necessary to set network settings, configure MTConnect, and setting up shares. Requirements Windows-based Smooth Control Accessing Windows Press the far-left softkey to reveal ...