How to Edit Haas 9000 Programs

How to Edit Haas 9000 Programs

Overview

By default, 9000 programs are protected and cannot be edited. Enabling a parameter is required to edit 9000 programs. 
It is absolutely critical you know what you are doing when working with 9000 programs. Changing or deleting a protected program can render the CNC machine inoperable and may require a qualified machine technician to repair it. 

Controls

  1. All Haas Controls, including Next Generation Control (NGC)
Notate or take a picture of any parameters before you change them

Enable Editing 9000 Programs

  1. Press SETNG GRAPH button
  2. Type "23", press Down Cursor button
  3. Press Right Cursor button to change to "ON"
  4. Press WRITE/ENTER Button

Disable Editing 9000 Programs

  1. Press SETNG GRAPH button
  2. Type "23", press Down Cursor button
  3. Press Right Cursor button to change to "OFF"
  4. Press WRITE/ENTER Button

    • Related Articles

    • How to Edit Fanuc 8000 & 9000 Programs

      Overview By default, 8000 and 9000 programs are protected and cannot be edited. Enabling a parameter is required to edit 8000 and 9000 programs. It is absolutely critical you know what you are doing when working with 8000 and 9000 programs. Changing ...

    • How to Save Haas Machine Data via RS232

      Overview This article will review how to save Settings, Macro Variables, Offsets, Parameters, etc. from a Haas Classic Control (CHC) via RS232. Requirements Haas CHC already connected to PC via RS232 Procedure to Save Machine Data via RS232 Go to ...

    • How to Set Haas RS-232 Parameters

      Controls All Haas prior to 2016 Any Haas 2016 or later with an RS-232 interface Notate or take a picture of any parameters before you change them Set Parameters Standard Transfers (Default) Press SETNG GRAPH button Press Page Down button until you ...

    • Why does Haas Output Tool Offset?

      Problem When uploading a program from the CNC to the server, the program includes O999999 (TOOL OFFSET). This will cause a remote request program to fail because the program will exceed the maximum lines allowed. Reason A parameter is turned on ...

    • How to Test a Haas Serial Port

      Overview The Haas loopback test can be used to test the integrity of the serial port. This procedure was provided by Haas and is an official test. Preparation Change setting 14 to CTS/RTS On port 1 (top port), jump the following pins on the upper (or ...