Parameters - Haas Classic Control

Parameters - Haas Classic Control

Controls

  1. Any Haas with a RS-232 Port (usually 2016 or older, formally called Classic Haas Control or CHC)
Warning
Notate or take a picture of any parameters before you change them

Set Parameters

Standard Transfers (Default)

  1. Press SETNG GRAPH button
  2. Press Page Down button until you find “RS-232 Ports” or a similarly named page (varies by Haas model year)
  3. Set Baud Rate Select to "9600" (2400, 4800, 19200, 38400 may also be used)
  4. Set Parity Select to "Even"
  5. Set Stop Bit to "2"
  6. Set Synchronization to "DC Codes"
  7. Set RS-232 Data Bits to "7"
  8. Set Leader to Punch to "None"
  9. Set EOB Pattern to "CR LF"
  10. Set Add Spaces RS232 Out to "Off"

High-Speed Transfers

  1. Press SETNG GRAPH button
  2. Press Page Down until you find “RS-232 Ports” or a similarly named page (varies by Haas model year)
  3. Set Baud Rate Select to "115200" (any baud rate may be used with XMODEM transfers)
  4. Set Parity Select to "None"
  5. Set Stop Bit to "1"
  6. Set Synchronization to "XMODEM"
  7. Set RS-232 Data Bits to "8"
  8. Set Leader to Punch to "None"
  9. Set EOB Pattern to "CR LF"
  10. Set Add Spaces RS232 Out to "Off"

    • Related Articles

    • Operator Guide - Haas Classic Control

      Overview This will explain how to output a program (send) from the CNC control and input a program (read) into the CNC control. Controls Supported Haas Classic Control (CHC) - 2016 or older How to Send Press LIST PROGRAM button Using the cursor, ...

    • Yasnac i80 RS-232 Parameters

      Control Yasnac i80 Notate or take a picture of any parameters before you change them Change Yasnac Parameters Press PROG key Press far right UP/DOWN softkey to select top row of softkeys (indicated by outlines) Press IN/OUT softkey Press RS232C ...

    • Fanuc 0 RS-232 Parameters

      Controls Fanuc 0M, 0T Notate or take a picture of any parameters before you change them Change Fanuc Parameters Put control in MDI mode Press DGNOS PARAM button until you see "PARAMETER" page Press PARAM softkey On SETTING 1 page, change the ...

    • Okuma OSP P100, P200, P300 RS-232 Parameters

      Controls OSP-P100L, OSP-P100M OSP-P200L, OSP-P200M, OSP-P200S, OSP-P200LA, OSP-P200MA, OSP-P200SA OSP-P300L, OSP-P300M, OSP-P300S, OSP-P300LA, OSP-P300MA, OSP-P300SA Notate or take a picture of any parameters before you change them Set Tape Puncher ...

    • Mazak Mazatrol 640 RS-232 Parameters

      Controls Mazatrol 640T, 640M Mazatrol 640T, 640M Nexus PC-Fusion-CNC Notate or take a picture of any parameters before you change them Set TAPE (EIA) Parameters Press far-left softkey Press DATA I/O Press TAPE Press PARAM. Set BAUDRATE to "19200" ...