How to Switch Between Doosan EZ Guide and Fanuc NC

How to Switch Between Doosan EZ Guide and Fanuc NC

Overview

Doosan machines have EZ Guide. Unfortunately, EZ Guide does not allow for serial RS232 program transfers. Luckily, it is easy to switch back and forth.

Switch to NC (Classic Fanuc Interface)

  1. Press CUSTOM1 button
  2. Press NC-P
  3. Press PROG button to confirm classic Fanuc interface loads

Switch to EZ Guide (Custom Doosan Interface)

  1. Press CUSTOM1 button
  2. Press EZG1
  3. Press PROG button to confirm EZ Guide interface loads

    • Related Articles

    • How to Change Fanuc Available Device for Ethernet Connectivity

      Overview When working with a Fanuc i Series control and you have confirmed the Ethernet cable is plugged into the CD38A port and the IP address configured correctly, but you are still having trouble connecting to the Fanuc, its likely due to the ...
    • How to Configure Fanuc Network and FOCAS Settings

      Overview This article includes steps to configure network and FOCAS settings. Requirements Static IP Address, Subnet Mask, & Gateway Network Drop Controls Fanuc 16i-MB, 16i-TB, 160i-MB, 160i-TB, 160is-MB, 160is-TB Fanuc 18i-MB, 18i-TB, 180i-MB, ...
    • Why does my Fanuc give "The Wrong Data is Used" error message?

      Problem When trying to send, punch, or output a program, the Fanuc give an error "The Wrong Data is Used". Reason This is a syntax error and most likely due to how the program name or number is being typed. In some cases, this is also due to the ...
    • How to Change Fanuc FTP Host

      Overview When using FTP with a Fanuc, you can have up to three hosts configured. This article includes steps to toggle between the different hosts. Requirements Fanuc control with configured FTP Host (How to Configure Fanuc FTP Settings) Changing FTP ...
    • How to Access Fanuc Interface from iHMI

      Overview Fanuc offers the new Intelligent Human Machine Interface (iHMI) on newer controls. To access the classic Fanuc interface, a few simple steps makes this possible. Exit iHMI Press Menu Button Press MAINTENANCE DISPLAY These buttons will ...