Siemens 810D Powerline RS-232 Parameters

Siemens 810D Powerline RS-232 Parameters

Controls

  1. Siemens 810D Powerline
Notate or take a picture of any parameters before you change them

Change Siemens 802D Parameters

  1. Press MENU SELECT button
  2. Press SERVICES
  3. Press SET
  4. Set the following parameters
    1. Interface to “COM1”
    2. Protocol to “XON/XOFF”
    3. Baud Rate to “9600”
    4. Data Bits to “7”
    5. Parity to “even”
    6. Stop Bits to “2”
    7. XON (hex) to “17”
    8. XOFF (hex) to “19”
    9. End of transfer to “1a”
    10. Check “Stop with EOT character”
  5. Press Save Settings

    • Related Articles

    • Siemens 802D RS-232 Parameters

      Controls Siemens 802D Notate or take a picture of any parameters before you change them Change Siemens 802D Parameters Press Menu Select button Press Services softkey Press Devices softkey Select Standard interface from top Press Copy to clipboard ...

    • Haas RS-232 Parameters

      Controls Any Haas with a RS-232 Port (usually 2016 or older, formally called Classic Haas Control or CHC) Notate or take a picture of any parameters before you change them Set Parameters Standard Transfers (Default) Press SETNG GRAPH button Press ...

    • Siemens 840D RS-232 Parameters

      Controls Any Siemens SINUMERIK 840D w/ RS-232 Notate or take a picture of any parameters before you change them Set Parameters Press MENU SELECT button Press Services softkey Press Interface softkey Press RS232C softkey (on the right) to get to the ...

    • Yasnac i80 RS-232 Parameters

      Control Yasnac i80 Notate or take a picture of any parameters before you change them Change Yasnac Parameters Press PROG key Press far right UP/DOWN softkey to select top row of softkeys (indicated by outlines) Press IN/OUT softkey Press RS232C ...

    • Fanuc 0 RS-232 Parameters

      Controls Fanuc 0M, 0T Notate or take a picture of any parameters before you change them Change Fanuc Parameters Put control in MDI mode Press DGNOS PARAM button until you see "PARAMETER" page Press PARAM softkey On SETTING 1 page, change the ...