Guides
How to Enable DNC (Drip-Feed) Mode on a Haas Classic Control
Overview Haas Classic Controls support DNC operation, i.e. drip-feed, via the MDI/DNC button. Normally MDI and DNC modes are toggled using the MDI/DNC button, but if this is not working, its likely not enabled. Enable DNC Mode Press SETTING or ...
Operator Guide - Haas Classic Control
Overview This will explain how to output a program (send) from the CNC control and input a program (read) into the CNC control. Controls Supported Haas Classic Control (CHC) - 2016 or older How to Send Press LIST PROGRAM button Using the cursor, ...
How to Configure Haas NGC DPRNT
Overview Haas with Next Generation Control (NGC) allows DRPNT, but not using the traditional RS232 port. You can export DPRNT statements using a TCP port or save it to a file. This is a common practice to collect probe data from the control. Set ...
How to Save Haas Machine Data via RS232
Overview This article will review how to save Settings, Macro Variables, Offsets, Parameters, etc. from a Haas Classic Control (CHC) via RS232. Requirements Haas CHC already connected to PC via RS232 Procedure to Save Machine Data via RS232 Go to ...
How to Check if Haas NGC Supports SMBv2 and NTLMv2
Overview SMBv1 and NTLMv1 have long been disabled by IT departments. Newer Haas Next Generation Controls support SMBv2 and NTLMv2. The easiest way to check is by checking the Net Share settings page. Check for SMBv2 Support Press SETTING button Go to ...
How to Locate Haas Spare 115vac Plugs
Overview Most Haas CNC machines have spare 115vac plugs that can be used for 115vac powered accessories. This article will help determine if your machine has them. Opening the electrical cabinet should only be performed by trained technicians. ...
How to Test a Haas Serial Port
Overview The Haas loopback test can be used to test the integrity of the serial port. This procedure was provided by Haas and is an official test. Preparation Change setting 14 to CTS/RTS On port 1 (top port), jump the following pins on the upper (or ...
How to Edit Haas 9000 Programs
Overview By default, 9000 programs are protected and cannot be edited. Enabling a parameter is required to edit 9000 programs. It is absolutely critical you know what you are doing when working with 9000 programs. Changing or deleting a protected ...
Parameters - Haas Classic Control
Controls Any Haas with a RS-232 Port (usually 2016 or older, formally called Classic Haas Control or CHC) Notate or take a picture of any parameters before you change them Set Parameters Standard Transfers (Default) Press SETNG GRAPH button Press ...
How to Configure Haas NGC Network Settings
Overview This will go over how to configure the wired Ethernet settings and Net Share on a Haas Next Generation Control. Configure Wired Connection settings Press SETTING button Go to Network tab Go to Wired Connection tab To set the following ...